VONROC GP808AA Bersetzung Der Originalbetriebsanleitung Seite 5

3. INSTALLING
Installing the filter (Fig. A, B, C)
1. Insert the filter (5) into the transparent housing
(4) and screw the housing onto the top section
(2) by using a spanner (6).
2. Apply thread seal tape (Teflon tape) to the
threaded coupling (7).
3. Screw the coupling (7) airthight into the filter
outlet (3), as shown on figure B1.
4. If the coupling of the suction hose (11) has a
female thread, an extra coupling (7) is needed.
Apply thread seal tape (Teflon tape, not inclu-
ded) to the threaded coupling (7).
5. Screw the coupling (7) airthight into the filter
inlet (1), as shown on figure B2.
6. Screw the pre-filter airthight on the water inlet
of the garden pump, as shown on figure C.
When the filter touches the ground, it is recom-
mended to use a wooden block between the
pump and the ground. The feet of the pump can
be bolted to the wooden block.
Wall bracket (Fig. A, C)
The supplied wall bracket makes it possible to
attach the filter to a pole or wall.
1. Put the wall bracket (9) on the top section (2).
2. Mount the wall bracket (9) by tightening the
four screws (8).
3. Mount the wall bracket (9) to a pole or wall by
tightening three screws or bolts (not included).
Attaching the suction hose (Fig. A, C)
Don't use any hose connection system
fittings or standard water hoses on the
suction side! A suction hose (11) set with
suitable coupling (G1" thread) and foot
valve must be used. The foot valve prevents
the return flow of the water at the end of
the pumping process.
25mm, 32mm or 38mm (inner diameter)
suction hose (11) must be used to achieve
maximum flow rate.
The suction hose (11) should be as short as
possible.
WWW.VONROC.COM
1. Fill suction hose (11) with clean tap water.
2. Apply thread seal tape (Teflon tape, not included)
to the threaded suction hose coupling.
3. Screw the suction hose coupling airthight into
the water inlet (1).
Filling the pump and filter with water (Fig. A, C)
Air in the filter will stop the garden pump
from working properly.
1. Unscrew and remove the air outlet (10) plug.
2. Fill the pump with clean tap water. Do not over-
fill the pump. See the pump manual. Check that
the filter is also filled with water.
3. Place the air outlet (10) plug back, do not over-
tighten.
4. The pre-filter is now ready for use.
4. MAINTENANCE
Cleaning (Fig. A, D)
For optimal performance it is recommended
to regularly change the filter (5) depending
on level of use.
1. Carefully remove the transparant housing (4) by
using a spanner (6).
2. Use a mild soap and water solution to clean the
filter (5) and the transparant housing (4) and
afterwards rinse with clean water.
3. Insert the filter (5) into the transparent housing
(4) and screw the housing onto the top section
(2) by using a spanner (6).
STORAGE AND FROST POTECTION
The pre-filter and accessories that are not completely
drained can be destroyed by frost. Completely drain
the pre-filter and accessories and protect them
against frost.
Keep this appliance in well-ventilated dry premises
with temperature not going below +5°C.
When not in use, keep this appliance stored in a
safe place out of reach of children.
EN
5