Profi-Partner 49307 Bedienungsanleitung Seite 2

EN
FINGERPRINT
PADLOCK XXL
Fingerprint Long Standby Time
I. USB Interface:
The product is charged by USB. Please
fully charge the product at the first time.
3
2
Components:
1. USB Port
2. Fingerprint Sensor
3. LED Light
III. How to collect the first administrator' s fingerprint
1. Press and 2. Move your finger
hold the when the blue light
sensor for 3 flashes.
seconds.
IV. How to collect the 2nd to 20th fingerprint
1. Admin press
and hold the
sensor for 3
seconds.
Remarks:
1. The first and second fingerprints are the admins by default.
2. Collecting the second to 20th fingerprints requires the administrator's fingerprint to enter the collection mode.
V. How to delete fingerprints
1. Admin press and
hold the fingerprint
sensor for 6s to 10s.
Remarks:
1. Enter deleting mode, press the operator's fingerprint, the operator's fingerprint was deleted.
2. Enter deleting mode, press the administrator's fingerprint, all of the fingerprints were deleted.
VII. Low voltage
When the voltage is ≤ 3.5V, the red indicator light will flash 5 times, indicating that it will enter the dormant state after low
power; if it has been in the low power state, touch the fingerprint to unlock the lock, the red indicator light will flash 5 times,
indicating that it is low power, and it will be in the dormant state again. At this time, please charge it as soon as possible.
0.5s Unlock
4
1
5
4. Shackle
5. Dust Cover
3. Start collecting
fingerprint when
green light
flashes.
2. Start collecting 3. Repeat collecting
fingerprint when the same fingerprint
the green light for 5 times.
flashes.
2. Use one of the
admins' fingerprints
to authorize.
Security
II. Indicator
Use 3-color indicator. Different indicator represents
different device and status.
Please check the details as below chart:
lndicator Light
Red light flashes
Red light on
Red light off
Green light flash
Green light always on
Blue light always on
Green light flashes fast
Red light always on
Red light flash
5. Failed to collect fingerprint
when the red light flashes.
4. Repeat collecting
the same fingerprint
for 5 times.
5. Successfully collected
fingerprint when the blue
light flashes.
4. Failed to collect
fingerprint when the red
light flashes.
4. Successfully collected
fingerprint when the blue light flashes.
3. Fingerprints deleted when
there is a long sound and green
light flashes.
Fingerprint Padlock Status
Low power
Recharging
Completely Charged
Fingerprint collection mode
Successful to collect
fingerprint
Administrator fingerprint
authorization
Unlock successfully
Delete fingerprint mode
Failed to collect fingerprint
6. There is a loud & long
sound „DI" and green
light flashes continuously
when finished collecting.
5. There is a loud & long
sound „DI" and green light
flashes continuously
when finished collecting.
VI. Specifications
Support 360 degree angel
fingerprint recognize
Resolution: 508DPI
ESD: +/-12kV air, +/-8kV contact
FRR: <1%
FAR: <0.002%
Recognize time: <300mS
Battery: 3.7V 300mAh
Charger: SV 200MA