Product Usage; Precautions - witeg MS-12D Bedienungsanleitung

3. Product usage

3.1 Precautions

You must read this manual carefully and completely before using
the device.
The device should only be operated by laboratory personnel especi-
ally trained for this purpose and familiar with all precautionary mea-
sures for working in a laboratory.
This product was manufactured to operate normally at the rated vol-
tage. Confirm the voltage state before the installation of product.
(DC 12V, with AC 100~240V Adaptor, 50/60Hz)
Place the device on a level, horizontal surface to support the capa-
city of the device without vibration. If there is vibration, install the
device on a support material with enough space. Too small space
may cause the device to fall.
Do not install at a dangerous place.
Do not operate the device near flammables. This may cause seri-
ous accidents like explosions or fire.
Do not use outdoors toavoid overheating or electrical fault. The use
where the sun continuously shines and where the device can get
rained on it is prohibited. It may cause overheating or electrical fault.
If the product was moved or stored in high humidity, check the state
of the products packaging before use.
In case the carton box or wooden box is soaked in water, consult
an engineer about the matter. Do not operate the equipment before
the safety is confirmed. A wet state may be the cause of an electric
shock or a fire.
This product should be operated in a room with temperature main-
tain between 5°C and 40°C. Long-term use in an environment that
exceeds this range may cause malfunctions.
The maximum relative humidity is 80% at 31°C and 50% at 40°C.
Do not install the product at gloomy place.
If the product is installed at gloomy place, unexpected accidents by
the movement mistake may occur.
www.witeg.de | Manual Mini/Midi magnetic stirrer MS-12D/-18D
15