Safety Warnings - Gemas STANDARD-Serie Einbau- Und Betriebsanleitung

To install the flange on the inner side of the swimming pool, make sure that the heads of the screws DIN 7981
4,8 x 16, which have been installed previously coincide with the area reserved for them on the back part of
the clamp.
Secure the clamp to the pool wall using 16 screws:
DIN 966 M6 x 24 point if the housing is for screws with metric pitch (Fig.4).
DIN 7982 5,5 x 25 if the housing is for self-threading screws (Fig.4).
4. ASSEMBLY:
After installation of the housing and the clamp, if it is a prefabricated swimming pool, assemble the flood lamp.
To connect the flood lamp to the electric power supply insert the cable through the gland seal nut (16). Tighten
the gland seal nut until you can verify that the cable will not yield when you pull on it with your hand.
Take the precaution of leaving 1,5 m of cable wound on the base of the flood lamp in order to able to remove
the flood lamp to the edge of the pool in the event that lamp replacement or handling is required. (Fig.5).
Insert the entire flood lamp assembly in the housing (Fig.6). In order to obtain good pool lighting it is important
that the anagram of the decorative ring is located on the upper part (Fig.7).
5. MAINTENANCE:
To remove the lamp, unscrew the 6 nuts which secure the decorative ring to the base of the flood lamp (Fig.9).
Remove the lamp from the inside of the base of the flood lamp and disconnect the two terminals, loosening
the two screws which secure them to the lamp. (Fig.10).
Change the lamp and assemble the flood lamp, in the opposite order described in point 4 of assembly, taking
special care to:
• Connect the cable terminals to the lamp, using the 2 screws supplied with the lamp (Fig.11).
• Fully centre the 110 x 11 O-ring in its seat.
• Firmly tighten the nuts.
Attention:
• Before any handling ensure that there is NO voltage supplied to the flood lamp.
• The new lamp should have the same characteristics as that supplied with the flood lamp, PAR 300 W 12V.
• In order to ensure full water tightness, clean the seat of the O-ring for the lamp or replace the O-ring if you
observe any notches or permanent damage.
6. START-UP:
Ensure that the voltage the lamp receives is never greater than 12 V.
The flood lamp should only operate underwater while secured to the vertical walls of the pool.
Never switch on flood lamp if it is not underwater.

7. SAFETY WARNINGS:

• The persons who are in charge of assembly should have the required qualifications for type of work.
• Avoid making contact with the electric voltage.
• Comply with the current standards regarding accident prevention.
• In this regard, the IEC 364-7-702 standards must be observed: WIRING IN BUILDINGS, SPECIAL
WIRING. SWIMMING POOLS.
• Any operation related to the maintenance or replacement of parts should be performed with the flood lamp
disconnected from the electric power system.
• Do not handle with wet feet.
• The manufacturer is not responsible in any circumstances for assembly, installation or start-up of any
components which have been inserted or handled at locations other than its own premises.