Thermrup EM623 Gebrauchsanweisung Seite 9

4. Operation
4.1 Commissioning
Before use:
• Connect the plug of the eye mask to the socket of the supplied temperature
controller.
• Plug the USB connector of the temperature controller into the supplied USB
adapter. (If necessary, a separate power bank can also be used as a power
supply).
• Plug the USB adapter into the socket (AC100—240V)
To turn on the heating function, press the "ON" button briefly until the display
shows the temperature "45".
4.2 Operation
• Now you can set the desired surface temperature of the eye mask: "40", "45
"or "50" (3-level temperature settings)
• Press the button plus "+" to increase the temperature or minus "-" to decrease
the temperature.
• Then put the eye mask to your eyes and fasten the mask around your head with
the connected Velcro strap.
• If you want to turn off the heating function, press and hold the power button
for about 1 second until the indicator shows a dot ".".
• After 13 minutes of continuous operation, the heating function will
automatically turn off. If you wish to continue using the device, press the On/Off
button again to resume using the eye mask according to your individual
temperature setting.
9