Checking The Cameras Image; Adjusting The Cameras Image - Eminent EM6015 Benutzerhandbuch

- Avoid direct sunlight into the camera, it could cause overexposure
- Place the camera on a spot which is not too easy for unwanted people to sabotage
the camera
1. Turn off the EM6015 by pressing the 'Power' button for a few seconds. A status
bar will be shown telling you when the EM6015 will be completely turned off.
2. Take the camera out of the packaging.
3. Connect the video cable of the camera to a 'Video In' connection of the EM6015.
4. Connect the power cable of the camera to one of the eight connections of the
supplied power breakout cable.

4.1 Checking the cameras image

1. Now you have installed a camera, the cameras image can be checked.
2. Turn on the EM6015.
3. As soon as the EM6015 has been started, you will see that the screen is divided
into nine squares. Each of the squares represents a camera-input.
4. If you have connected the camera to the 'Video-In 1' connection, you will see the
cameras image appear in the upper left corner on your monitor.
Double-click the square which represents the cameras image to see the cameras
image in full screen.

4.2 Adjusting the cameras image

It is possible to alter the screen resolution. Use the following steps.
1. Make sure the EM6015 is completely started and you see the EM6015's image
on screen.
2. Click the right mouse button once.
3. Click 'Main Menu'.
4. Enter your password (if setup before) or leave it empty.
5. Click 'Basic'.
6. Click 'Video/Audio'.
7. Set the desired resolution at 'VGA Resolution'. In case you have connected the
DVR to a wide screen LCD display which supports high resolutions, you can
select '1366x768'.
8. Set the correct television system at 'Camera System'. In Europe, 'PAL' is
commonly used. NTSC is mostly used in North-America and Japan.
9. Click 'Apply'.
10. Click 'OK' to confirm the chosen resolution and television system.
11. Click 'Exit' until you are at the main menu.
29 |
ENGLISH