How To Install - Lionelo Twee Go Bedienungsanleitung

The product complies with requirements of EU directives.
Pursuant to the Directive 2012/19/EU, this product is subject to selective collection. The product must not
be disposed of along with domestic waste since it may pose a threat to the environment and human health.
Worn-out product must be handed over to the electrics and electronics recycling point.
Device outline (fig. 1)
1.
Protective cover
2.
Silicone funnel
3.
Breast pump T-connection
4.
Membrane cover
5.
Silicone membrane
6.
Suction valve
7.
Milk bottle
Touch screen outline (fig. 2)
1.
Massage and suction display
2.
Milk stimulation mode
3.
Mode switching
4.
Level down
Breast pump modes (fig. A)
1.
Milk stimulation mode – 5 levels. Massage stimulates initial child suction
phase while breastfeeding.
2.
Milk drawing mode – 9 levels. This mode stimulates deeper child suction
phase while breastfeeding.

How to install

1.
Position the silicone funnel (2) on the breast pump T-connection (3). Make
sure the funnel flange is properly attached (fig. 3).
2.
Place the silicone membrane (5) on the breast pump T-connection (3). Make
sure the membrane flange is properly attached (fig. 4), and then put the
membrane cover (4) on.
3.
Insert the suction valve (6) into the lower hole of the breast pump T-connection
(3). Make sure the valve is pushed as fast as possible. Note: insert the suction
valve gently to avoid damage. Do not use the valve (fig. 5) if it is damaged.
EN
8.
Main motor
9.
Tube
10. Milk bottle cap
11. USB cable
12. Milk bag adapter
13. Milk bag
14. Connector
5.
Battery indicator
6.
Milk drawing mode
7.
Level up
8.
On/off switch
‑ 6 ‑