Black & Decker kw800 Handbuch Seite 29

USING THE CENTRING PIN
centring pin to the edge guide with the screw provided.
USING THE COPY FOLLOWER
The copy follower helps maintain an equal cutting
distance along the edge of irregularly shaped workpieces.
To fit the copy follower, proceed as follows:
c
a
provided. Adjust the edge guide in the base of your
router until the wheel is in contact with the workpiece.
ROUTER BITS
• Only use cutters with a shank size of 6mm, 8mm or
1/4" with the equivalent collet size provided.
Rounding, rebating and laminate bits have either a
ball bearing or a pilot pin for use at the edge of the
workpiece. Most of the following router bits are
available in two different grades:
• HSS cutters for use on softwood.
• TCT cutters for use on hardwood, chipboard plastics
and aluminium.
No Description Purpose
1 Straight bit Channelling
2 V-Grooving bit Chamfers, grooves and letter work
3 Core box bit Grooves, edge profiles and drop-
leaf joints
4 Dovetail bit Dovetail grooves
5 Rounding bit Profiles and drop-leaf joints
6 Roman ogee bit Profiles
7 Rebating bit Easy rebates
8 Laminate bit Trimming wooden or laminate
horizontal projections
KW800_E ML p24-41
1
The centring pin
enables you to use
your router as a
compass to cut
out, scribe or
produce circular
patterns. Attach the
5
Attach the 'L' bar
(a) to the edge
guide (b) using the
HANDY HINTS
two screws and
nuts provided.
Attach the
rotating
attachment (c) to
b
the 'L' bar with the
wing screw
right as you stand facing the workpiece.
• When cutting outside edges, move your router anti-
TOOL CARE
Do not apply excessive pressure when you use your
router. This can cause your router to overheat. If your
router becomes too hot, operate it off-load for
2 minutes. Keep the air cooling vents on the motor clear.
EC DECLARATION OF CONFORMITY
We declare that units: KW800, KW800E conform to
98/37/EC, 89/336/EEC, EN55014, 73/23/EEC, EN50144,
EN61000. A weighted sound pressure 85.5dB (A),
A weighted sound power 98.5dB (A), Hand/arm
weighted vibration 2.7m/s
Black & Decker, Spennymoor, Co Durham DL16 6JG, UK
29
ENGLISH
2 3
6 7
clockwise and clockwise when cutting inside edges.
2
Brian Cooke, Director of Engineering
16-01-2001, 13:45
4
8
You can use your
router without
using a guide.
This is useful for
signwriting and
creative work.
Use only
shallow cuts.
The cutter of your
router rotates
clockwise. For
more efficient
cutting, move your
router from left to
29