Marshalltown BULLET SHARPSHOOTER PRO Bedienungsanleitung Seite 8

Replacing the Blade
WARNING: Blade is extremely sharp! Use cut-resistant gloves when replacing
the blade.
1. TURN SHEAR UPSIDE DOWN Tip: put the shear on the edge of a sturdy table.
2. LOOSEN BLADE Using a Phillips screwdriver, remove the screws.
3. REMOVE BLADE Hold blade by each end and carefully lift out of pocket.
4. INSTALL BLADE Hold blade by each end and carefully place into the blade pocket
in the head, with the flat side of the blade facing the table. Be sure that it is firmly
seated, and the pocket is clear of debris.
5. TIGHTEN THE BLADE Using a Phillips screwdriver, replace & tighten the screws,
starting with the center screw.
NOTE: This image is for the SharpShooter 2.0. Your shear may look slightly different.
Lubrication
After every 100 cuts, it is recommended that the shear be lubricated. Use a light oil and grease (wheel bearing
grease) and apply according to the image below. Lubricating the shear will extend the life of the shear and
result in easier cutting.
Grease
Oil
8 of 14
WS2550revA
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com