Fit The Pole Saw; Use The Shoulder Strap; Cutting Preparation; Install The Battery Pack - GreenWorks GD60PS Bedienungshandbuch

6. Hold the chain and bar.
7. Put the chain loop around the sprocket.
8. Make sure the chain tension pin hole on the guide bar fits
correctly with the bolt.
9. Install the chain cover.
10. Tighten the chain. Refer to Adjust the chain tension.
11. Tighten the chain cover knob when the chain is well
tensioned.
If you start the chain saw with a new chain, have a test for
2-3 minutes. A new chain gets longer after the first use,
examine the tension and tighten the chain if necessary.
3.4

FIT THE POLE SAW

Figure 2
Before using the pole saw, assembly is required. When
removed from the box, there are the three poles.
1. Insert the extension pole into the handle pole and slide
together. The tubes are oval-shaped and will only install
one way.
2. Push the extension pole into the lock sleeve in the handle
pole and the press button will lock into the press button
hole. Then use a wrench to secure the lock nut.
3. Repeat this process to attach the extension pole to the
power head pole.
3.5

USE THE SHOULDER STRAP

Figure 3
1. Attach the carabiner to the carrying ring on the pole.
2. Put on the shoulder strap.
3. Adjust the length of the strap so that the carabiner is
about the width of a hand below your right hip.
3.6

CUTTING PREPARATION

Figure 3
Before you start to cut, make sure that
• Wear heavy gloves for maximum grip and protection.
• Maintain a proper grip on the machine during operation.
• Use your right hand grip on the rear handle while
your left hand grip on the pole shaft.
• Keep your body to the left of the chain line.
• Never use a left-handed (cross-handed) grip, or any
stance that places your body or arm across the chain
line.
• Never stand directly under the limb you are cutting.
• Periodically examine the tightness of the collars during

operation.

NOTE
English
3.7

INSTALL THE BATTERY PACK

Figure 4
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read, know, and do the instructions in the battery and
charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
3.8

REMOVE THE BATTERY PACK

Figure 4
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
4 OPERATION
Remove the battery pack and keep hands clear of the lock
out button when you move the machine.
Examine the chain tension before each use.
4.1 EXAMINE THE CHAIN
LUBRICATION
Do not use the machine without sufficient chain lubrication.
Figure 5
1. Examine the lubricant level from the oil indicator.
2. Add the lubricant if it is necessary.
4.2

START THE MACHINE

Figure 6.
1. Press the lock-out button.
2. Press the trigger while you hold the lock-out button.
3. Release the lock-out button.
4.3

STOP THE MACHINE

Figure 6.
1. Release the trigger to stop the machine.
5
WARNING
NOTE
IMPORTANT
NOTE
EN