Seamaid 501214 Montage-& Wartungshandbuch Seite 5

IMPORTANT : This instruction manual includes essential information on the safety measures to be
implemented for installation and start -up. It is important to read these instruc tions before beginning
installation and start-up. Keep this manual for future reference .
Failure to comply with the instructions given by the manufacturer in this manual regarding
installation, operational start up and maintenance of the product exonerate s the manufacturer or the
distributor from any liability for damages affecting persons, the concerned product or the other
installations, and shall void the guarantee .
1. VERIFY THE CONTENT OF THE PACKING

Stainless Steel LED projector ~12V provided with 2 meters of 2x1,5 mm² HO7RNF
cable

Manual of installation and maintenance
2. GENERAL CHARACTERISTICS
This projector has been designed to be used both, outdoor or immerged in fresh water. It is a Class III
electric apparatus with very low safety voltage ~12V.
This projector complies with IP68 degree of protection and must be installed at a maximal immersion
depth of 1 meter.
This projector complies with international standards for lights, especially the EN 60598-2-18
standards, lights for swimming pools and similar applications.
3. INSTALLATION
For a correct installation, the power socket which feeds the installation projector will have to possess a
device of protection by residual current with a maximal intensity of 30 mA.
This projector will be only connected to a ~12V security transformer with double winding. Another type
of transformer is prohibited.
The power of this transformer will be always higher than the power of all projectors connected.
The manufacturer is not responsible in any circumstances for assembly, installation or start-up of any
electric components which have been inserted or handled at locations other than its own premises.
4. ASSEMBLY

Before any operation, turn OFF the power supply to bulb

Connect the cable supplied with the projector to the power cable in a waterproof
junction box

Fix solidly the projector

Assure that the power supply voltage is only ~12V

In case of use in immersion, check the waterproofness of the support

Switch on the projector
5. MAINTENANCE
This projector does not require any type of maintenance work. In case of improperly working, please
contact our customer service or the customer service of our dealer.
6. OPERATION
This LED projector is operating as a traditional incandescent lamp.
The driving mode is given by the On/Off interrupter in the electric panel.
An optional ~12V radio remote controller of the same brand can be installed.
The system offers 16 programs including 11 static colours and 5 automatic modes.
The control is made manually by short cuts of the current. Each fast cut of the current (less than 2
seconds) makes change the programs. After leaving the lamps OFF for over 10 seconds, switch ON
restarts from the last program used.
ENGLISH