CLAS OP 0206 Montageanleitung Seite 6

OP 0206 - OP 0306
It is necessary that the jack and the vehicle are on the same plane. Furthermore the surface where the jack is
installed has to be levelled out.
CAUTION
OP 0206 AND OP 0306 ARE NOT LIFTS, FOR THIS REASON IT IS FORBIDDEN ANY USE WHICH DIFFERS
FROM THE ONE PROJECTED FOR THESE EQUIPMENTS.
Connect the jack to a compressor able to reach 7 bar pres-
sure and connected to the proper plug (1) on the left side of
the distributor attached to the jack handle.
Position the jack under the vehicle to lift and press the left
button (green - ascent) of the distributor box.
Once the repairing operations on the vehicle have been
nished, press the right button (red - descent) to lower the
vehicle.
PNEUMATIC FLOOR JACK 2T-2 OR 3 STAGES
USE
DO NOT WAIT UNDER THE RAISED
VEHICLE.