KILLABEE 8212 Bedienungsanleitung Seite 9

STEP 9 : Attach Seat Cushion and Back Cushion, align the adjusters
over the pre-drilled holes underneath the back cushion with M8*25mm
Bolts, tighten all the bolts with the wrench.
Note: Please tighten the Bolts to 50%, not 100%.
K
STEP 10: Adjust balance of the full chair, then tighten all bolts to
100% on each side of adjuster.
STEP 11: Attach the Plastic Cover on right and left side with four
M5*8mm bolts, using the wrench.
E-mail: service@killabee-gaming.com
ASSEMBLY INSTRUCTIONS
E
J
3
4
4
2 F
9
Web: www.killabee-gaming.com
K