Technical Specifications; Important Safeguards - ARESA AR-3305 Bedienungsanleitung

ENGLISH
After unit transportation or storage at low temperature it is necessary to keep it for at least 4 hours at room temperature before switching on.
Supply voltage: 220-240 V ~ 50 Hz
Power consumption: 29-38 W
• Read this manual carefully before operating the unit to avoid damage during use. Wrong usage may lead to damage to the product, cause material damage
or cause damage to the health of the user.
• Before switching on make sure that the product specifications match the mains voltage.
• The device should not be used by persons (including children) with reduced physical, sensory or mental abilities, or lack of experience or knowledge, if
they are not controlled or instructed about the use of device by the person responsible for their safety.
• Only for domestic use in accordance with these instructions. The device should not be used in commercial and / or industrial purposes.
• Do not spray hair styling products while the appliance is in use.
• Do not use the appliance near water in bathrooms, showers, swimming pools, etc.
• To reduce the risk of electric shock do not immerse the appliance in water or other liquids. If this happens, DO NOT TOUCH the product, immediately
unplug it from the electrical outlet. Do not put your hands in water. Contact an Authorized Service Center for checking it.
• Children should be supervised to ensure that they do not play with the appliance.
• Do not use outdoors or in high humidity, especially near bath, shower or pool.
• When disconnecting the appliance from the mains, hold the plug by hand, do not pull on the power cord.
• Always unplug the appliance if it is not in use.
• Do not leave the appliance switched on unattended. • Do not use accessories not supplied with this unit.
• Do not carry the appliance by the cord.
• Do not repair the appliance yourself. Bring it to an authorized Service Center.
• Do not use the appliance with a damaged power cord or plug, or if it has been exposed to liquids, dropped or damaged in any other way. Do not attempt
to disassemble and repair the device yourself, contact the service center.
• Make sure that the power cord does not touch sharp edges or hot surfaces.
• Before switching on the unit make sure that the mode switch is in 'off; position.
• Do not use the device for styling synthetic wigs.
• Avoid overheating and direct sunlight.
Be careful during operation, do not allow the heating element of the device to come into contact with unprotected skin. The working area is heated to 200 ° C.
Avoid touching heated surfaces with a power cord.
WARNING: Do not use this appliance near bathtubs, showers, basins or other vessels containing water.
Be careful during operation, do not allow the heating element of the device to come into contact with unprotected skin.
Attention: Place the device on a level, stable and heat-resistant surface.
Your new device has a protective coating of the heating element. At the first start-up and heating, a short, brief smoke and odor may appear. It is
safe to use and does not mean a defect of the device. When using it for the first time, wait until smoke and odor cease. This can last
no more than 30 seconds.
Operation mode of the device: after 30 minutes of operation, break for at least 15 minutes.
Wash the hair before setting it. For achieving the best result thoroughly wash the hair after using hair conditioner. Dry the hair with a towel.
• It is recommended to use a detangler before operating the device.
• Do not manipulate the same strand of hair for too long.
• When setting your hair manipulate hair strands evenly. Unwind the power cord to the full.
• Connect the appliance to the mains.
• Set the ON/OFF switch to "ON" position. The operation indicator will light.
• After a few minutes the device will heat up.
WAVING
• Separate the hair strand width of 2-4 cm.
• Hold a strand between the working surfaces of the heating elements. One working surface of the cylinder is two, the other - one. With these
cylinders wave comes naturally. • Move from the roots to the tips. Do not linger long on one strand.
• When finished, set the "On / off" switch to "Off" position and disconnect the plug from the socket. Make sure that the indicator light goes out, that
means the device is disconnected from the power supply. Do not touch the plates immediately after usebecause they are still hot.
TRANSPORTATION. Transportation of the device is necessary by any kind of covered transport with the application of cargo securing rules
ensuring preservation of the presentation of the product and / or packaging and its further safe operation. DO NOT expose the device to shock
loads during handling operations.
CLEANING. The device doesn't need maintenance and doesn't contain any parts that require user intervention.
For cleaning, first disconnect the device from the mains supply, let them cool down. Always clean only fully cooled device. Wipe the handle with
a soft, slightly damp cloth. Do not allow water to enter the handle.
STORAGE. The device must be stored indoors, in conditions that presume the preservation of the presentation of the product and its further safe
operation. Make sure that the appliance and all its accessories are completely dried, before storing it. To avoid damaging the cord, do not wind
it or hang by the power cord.
Please read this instruction manual carefully before using the appliance.
This device is designed for for modeling and styling hair. For household use, not suitable for industrial use.
The device is intended for use only for domestic purposes in accordance with this Instruction Manual.

TECHNICAL SPECIFICATIONS

IMPORTANT SAFEGUARDS

OPERATION
Save the instruction manual as you may require it in future.
Warranty period in the European Union - twenty four months