ARESA AR-1106 Bedienungsanleitung Seite 5

ENGLISH
After unit transportation or storage at low temperature it is necessary to keep it for at least 4 hours at room temperature before switching on.
Supply voltage: 220-240 V ~ 50 Hz
Power consumption: 1000 W
Before using the unit, read this instruction manual carefully and keep it for future reference.
Use the unit for intended purposes only, as specified in this manual. Mishandling of the unit may lead to its breakage and cause harm to the user or damage to his/her property.
• Before connecting the unit to the mains, make sure that the voltage specified on the unit corresponds to your home mains voltage.
• Never leave the unit connected to the mains unattended.
• Always unplug the unit before changing the attachments and after using it.
• Before using the unit, make sure that the attachments are set and fixed properly.
• Do not connect the motor unit to the mains if the attachments are not installed.
• It is not allowed to switch the unit on without attachments and foodstuffs for processing.
• Do not use the unit outdoors.
• Cool down hot products before putting them into the measuring cup or the chopper bowl.
• Do not place the chopper bowl and the measuring cup into a microwave oven.
• Use only the attachments supplied.
• Before using the unit for the first time, thoroughly wash all the removable attachments and containers that will contact food.
• Products should be put into the cup before the unit is switched on.
• Do not overfill the measuring cup with food and watch the level of poured liquids.
• The cutting edges of the blender attachment is very sharp and dangerous. Handle this attachment very carefully!
• Do not let hair or free hanging clothes get into the rotation area of the blender attachment knife or whisk.
• Unplug the unit every time before cleaning or when you are not using it.
• Unplug the unit by taking the power plug directly.
• Do not pull the power cord and do not twist it.
• Do not put the attachment and motor part in a dishwashing machine.
• Do not use the unit near hot surfaces (such as gas or electric stove, oven).
• Provide that the power cord does not touch sharp edges of furniture and hot surfaces.
• Do not touch the motor unit body, the power cord and the plug with wet hands.
• For children safety reasons do not leave polyethylene bags used as a packaging unattended. Attention! Do not allow children to play with polyethylene bags or packaging
film. Danger of suffocation!
• Do not allow children to touch the body of the motor unit, the power cord or the power plug during operation of the unit.
• Do not leave children unattended to prevent using the unit as a toy.
• During the unit's operation and breaks between operation cycles, place the unit out of reach of children.
• The unit is not intended for usage by physically or mentally disabled persons (including children) or by persons lacking experience or knowledge if they are not under
supervision of a person who is responsible for their safety or if they are not instructed by this person on the usage of the unit.
• Close supervision is necessary when children or disabled persons are near the operating unit.
• This unit is not intended for usage by children.
• Do not use the unit if the power cord or plug is damaged, if the unit works improperly or after it was dropped.
• Do not attempt to repair the unit. Do not disassemble the unit, if any malfunction is detected or after it was dropped, unplug the unit and apply to any authorized service
center.
• To avoid damages, transport the unit in the original package only.
• To avoid risk of electric shock or fire, do not immerse the unit body, the power cord and the power plug into water or any other liquids.
• If the unit is dropped into water:
– do not touch the water;
– unplug the unit immediately, only after that you may take the unit out of water;
– apply to the authorized service center for testing or repairing the unit.
• Keep the unit out of reach of children.
1. Install the hand blender attachment into the motor base by turning the motor part counter-clockwise until the blender attachment
is completely fixed.
2. Plug in the appliance. Put the blender into the cup. Then select the operating mode "1" or "2" and press the speed button "1" or "2".
When operating in the 1st mode, the speed of rotation of the blender knife can be adjusted using the speed controller. To do this, while
holding down the first mode button, move the speed control knob to the right or left, respectively, to increase or decrease the blender's
blade speed.
3.Afer the use disconnect the blender from the network. Wait until the blender knife is completely stopped. Then disconnect the hand
blender attachment from the motor part.
Attention! The knife blade is very sharp!
TRANSPORTATION. Transportation of the device is necessary by any kind of covered transport with the application of rules fastening of cargoes ensuring
preservation of the presentation of the product and / or packaging and its further safe operation.
DO NOT expose the device to shock loads during handling operations.
CLEANING. ATTENTION! Never wash parts of the appliance in the dishwasher. Do not use chemicals or abrasives. Always unplug the appliance before
cleaning. Clean the motor part with a soft, slightly damp cloth. Do not wash it under running water or immerse it in water or other liquids.
For washing, use warm water (not more than 50 ° C) and a usual detergent, be careful with the blades, as they are very sharp. Parts of the appliance having
direct contact with food must be cleaned every time after use. ATTENTION! Do not use grills or knives with a damaged working edge, covered with corrosion
or contaminated.
STORAGE. The device must be stored indoors, in conditions that presume the preservation of a presentation product and its further safe operation. Make
sure that the appliance and all its accessories are completely dried, before storing it.
Please read this instruction manual carefully before using the appliance.
TThe device is intended for grinding food, preparing cocktails, mousses, mashing, beating beverages, etc.
The device is intended for use only for domestic purposes in accordance with this Instruction Manual.
TECHNICAL SPECIFICATIONS
IMPORTANT SAFEGUARDS
OPERATION
Save the instruction manual as you may require it in future.
For household use, not suitable for industrial use.
Service lifetime - 3 years
Warranty period - 12 months