G20087; Display; Buttons; Install Battery Pack - TREVIDEA G3 FERRARI NATURA KITCHEN Bedienungsanleitung

- Not suitable for commercial use. Suitable only for household use.
- Do not immerse in water or other liquids and avoid splashing of water; clean it with a damp cloth
only. Do not subject the product to strong impacts, serious damage may result.
- Do not use as a shelf for supporting objects.
DESCRIPTION G20087
1 ON/TARE button
4 UNIT button

DISPLAY

In the middle the weight value is visualized
At the bottom, the weighting unit. On the left, starting from the top, the following symbols:
T, TARE indicator
MODE: weight mode,
BUTTONS DESCRIPTION
ON/ZERO button (1): Press to turn on/off the unit, and for TARE function
UNIT button (4): Press to change weighting mode and to change unit

INSERT BATTERIES

The compartment for battery is under the scale. The scale works with 3 x AAA, 1.5V battery.
- Open the door by pulling the lock tab.
- Remove discharged batteries eventually present in the compartment.
- Insert the battery following the signs (+ -) written in the body.
- Insert batteries, lock them and close the cover.
CAUTION
- Always use batteries AAA, 1.5V type.
- Be sure to insert the battery according to the correct polarity as otherwise they may leak and damage
the scale. Such damage is not covered by warranty.
- When you are going not to use the unit for a long time, it is advisable to remove the battery to prevent
the run-out.
- Whatever the type of exhausted battery, it must not be thrown in the household waste, in the fire or in
the water. Each type of exhausted battery must be recycled or disposed of in the appropriate dedicated
collection centers.

OPERATING

How to weigh
- Locate the scale on a stable surface.
- Place a bowl or a dish on the scale.
- Press the ON/TARE (1) and wait for the scale to display 0.0 and carry out the weighing.
Tare / Zero function
Tare function should be used when you want to perform several weighing using different containers, or
to display zero.
- Press the ON/TARE button (1)
- If the display (3) shows "0g" and the symbol T, keep on weighing.
- If the display (3) shows "unSt", it means that the value is not stable. Wait a few seconds.
2 BASE
5 Body
-, negative value
milk volume mode,
3 LCD display
water volume mode
5