Herunterladen Diese Seite drucken

ARESA AR-3312 Bedienungsanleitung Seite 5

Zange für modellierung der frisur

Werbung

ENGLISH
• Do not use accessories not supplied with this unit.
• Do not carry the appliance by the cord.
• Do not repair the appliance yourself. Bring it to an authorized Service Center.
• Do not use the appliance with a damaged power cord or plug, or if it has been exposed to liquids, dropped or damaged in any other way. Do not attempt to disassemble
and repair the device yourself, contact the service center.
• Make sure that the power cord does not touch sharp edges or hot surfaces.
• Check the appliance before switching on. In case of damage of the appliance and the power cord, never plug the appliance into an outlet. Contact an Authorized Service
Center.
• Before switcjing on the unit make sure that the mode switch is in 'off' position.
• Do not use the device for styling synthetic wigs.
• Avoid overheating and direct sunlight.
• Be careful during operation, do not allow the heating element touch unprotected skin.
• Attention: Place the device on a level, stable and heat-resistant surface.
• Avoid touching heating surfaces with a power cord.
• The manufacturer reserves the right, without additional notice, to make minor changes to the design of the product, cardinally not affecting its safety,
operation and functionality.
WARNING: Do not use this appliance near bathtubs, showers, basins or other vessels containing water.
• To model hair, the hair must be clean, dry and free of varnish, gel, and other hair styling products. Your tongs can always be used to quickly fix a hairstyle.
• Place the desired plate on the forceps by pressing it in until it clicks in the correct position. To remove the plate, press the plate release button, then pull
upward to remove it from the mount.
• Unwind the power cord completely. Place the device on a smooth, flat surface, plug them into the mains, set the On / Off switch to On, so the indicator should
light up and allow the tongs to warm up (about 3 -4 minutes).
• Divide the hair into strands, hold the strand between the plates to lock in this position for 1-2 minutes.
• The device includes:
- Straightening plates - for straightening curly hair
- Mini and maxi wave plates: to make straight hair wavy.
Do not brush your hair immediately after styling. Do not touch the plates immediately after use, because they are still hot.
• When finished, set the On / Off switch to Off and disconnect the power plug from the mains. Make sure that the indicator light goes out - that is, the appliance
is disconnected from the power supply.
Be careful, during operation, do not allow the heating element of the device to come into contact with unprotected skin. The working area is heated to 225 ° C.
Attention: Place the device on a level, stable and heat-resistant surface. Avoid touching heated surfaces with a power cord.
Your new device is provided with a protective coating of the heating element. At the first start-up and heating, a short, brief smoke and odor may appear.
It is safe to use and does not mean a defect of the device. When using it for the first time, wait until smoke and odor cease. This can last no more than 30
seconds. Operation mode of device: after 30 minutes of operation, break for at least 15 minutes.
TRANSPORTATION. Transportation of the device is necessary by any kind of covered transport with the application of cargo securing rules
ensuring preservation of the presentation of the product and / or packaging and its further safe operation. DO NOT expose the device to shock
loads during handling operations.
CLEANING. Before carrying out maintenance or cleaning operations, remove the plug from the power outlet and wait for the appliance to cool.
Do not use abrasives or solvents for cleaning.
STORAGE. The device must be stored indoors, in conditions that presume the preservation of the presentation of the product and its further safe
operation. Make sure that the appliance and all its accessories are completely dried, before storing it. To avoid damaging the cord, do not wind it
on the body.
When purchasing the product, ask for it to be checked in your presence. Without the having a warranty card or when it is not properly filled in,
the quality claims are not accepted, and no warranty repair is performed. The warranty card should be presented at any address to the service
center during the whole warranty period. The product is accepted for service in a complete set only. The warranty period is calculated from the
moment of sale to the buyer. Keep the documents confirming the date of purchase of the product (cash receipt).
The condition of free warranty service of your product is its correct operation, which does not go beyond personal domestic needs, in accordance
with the requirements of the operating instructions for the product, the absence of mechanical damages and the consequences of careless
handling of the product.
1. Defects caused by force majeure.
2. Damage to the product caused by the use of the product for purposes that go beyond personal domestic needs (ie industrial or commercial
purposes).
3. Consumables and accessories (sections, etc.).
4. Defects caused by overloading, improper operation, penetration of liquids, dust of insects, ingress of foreign objects into the product.
5. Products that have been repaired outside authorized service centers or warranty workshops.
6. Damage resulting from changes in the design of the product by the user or unqualified replacement of his components.
7. Mechanical damages, including due to negligent handling, improper transportation and storage, falling of the product.
8. Violation of the operating instructions.
9. Incorrect installation of mains voltage (if required).
10. Making technical changes.
11. Damage through the fault of animals (including rodents and insects).
Production month: refer to the information on the gift box.
For warranty service, please contact your nearest service center.
OPERATION
CLEANING, MAINTENANCE AND STORAGE
WARRANTY TERMS
OPERATION
THE GUARANTEE DOES NOT COVER:

Werbung

loading