Connecting The Power Supply - X4-TECH TP-1000 Bedienungsanleitung

resp. TAPE PLAY).
resp. TAPE REC).
er A-1000, connect the remote input REMOTE SYSTEM TO AMP
control the cassette recorder with the remote system.

Connecting the power supply

Make sure that, before you connect device to the power supply grid, the operating
(position "OFF").
The POWER (1) switch does not entirely disconnect the device from the electricity
supply. In order to completely separate the device from the electricity net, you have
to pull the mains plug out of the wall socket.
› Connect the mains plug of the cassette recorder to a socket (230 V~/50 Hz) linked to the public
power supply network.
32 Chapter 4 Connection
er (often marked with TAPE IN
er (often marked with TAPE OUT
er. You can then
Operation
1 2 3 4
LEVEL M ET ER IN DIC AT ION
N OIS E R EDUC TION
FW D
A
DY N AM IC N O IS E RED UC TION
PLAY F U LL AUTO ST OP SYSTEM OF F ON
PLAY C rO 2 D UBBIN G H I.SP.DU B.
PO WE R
ON O FF
PLAY R EW F F STOP/EJ. PA USE
7 11 10 9
(1) POWER button
Position ON > Device is turned on.
.
(2) Cassette drives
Please put the cassette into the recorder. The device has two drives, deck A is for playing,
deck B is for playing and recording.
(3) Switch NOISE REDUCTION
Use this switch (shift it to ON) to activate the dynamic hissing rejection system.
(4) Display reading
This display shows the level of the signals when recording resp. playing and also shows
device conditions.
(5) Tape counter for deck B
nd certain tape points. Press the button beside the coun-
ter to set back to 000.
5
5 6 2
DEC K B C O UN TER
RE C LEVEL
FWD
B H IGH S PEED DU BBIN G
RE C /P LAY FU LL AUT O ST OP SY STEM
MI N MAX
RE C CrO2
RE C P LAY REW FF S TOP/EJ. PAUSE
8 7
.
Chapter 5 Operation
33