Hama 00200004 Bedienungsanleitung Seite 3

G Operating instruction
1. Explanation of warning symbols and notes
Risk of electric shock
This symbol indicates a risk of electric shock from
touching product parts carrying hazardous voltage.
Warning
This symbol is used to indicate safety instructions or to
draw your attention to speci c hazards and risks.
Note
This symbol is used to indicate additional information or
important notes.
2. Package contents
• Universal notebook power supply unit
• Wrench (to switch the voltage)
• 8 notebook connectors
• Power cord
• These operating instructions
3. Safety instructions
• Use the product only for the intended purpose.
• Do not use the product in the immediate vicinity of
heaters, other heat sources or in direct sunlight.
• Ensure there is su cient scope for heat dissipation and
ventilation.
• Only use the article under moderate climatic conditions.
• Do not use the product in areas in which electronic
products are not permitted.
• Do not use the product in a damp environment and
avoid splashing water.
• Do not short-circuit the battery of the opened terminal
device. There is a risk of explosion.
• Protect the product from dirt, moisture and overheating
and use it in dry environments only.
• Do not drop the product and do not expose it to any
major shocks.
• Do not operate the product outside the power limits
speci ed in the technical data.
• Always pull directly on the plug when disconnecting the
cable, never on the cable itself.
• Make sure that cables do not pose a tripping hazard or
block emergency exits.
• Do not bend or crush the cable.
• As with all electrical products, this device should be kept
out of the reach of children.
• Do not modify the device in any way. Doing so voids the
warranty.
• Keep the packaging material out of the reach of children
due to the risk of suffocation.
• Dispose of packaging material immediately in
accordance with the locally applicable regulations.
2
Risk of electric shock
• Do not open the device or continue to operate it if it
becomes damaged.
• Do not use the product if the AC adapter, adapter
cable or power cable is damaged.
• Do not attempt to service or repair the product
yourself. Leave any and all service work to quali ed
experts.
4. Start-up and operation
Note – mains voltage 100 – 240 V
The power supply unit is suitable for mains voltages
of 100 – 240 V and therefore can be used worldwide.
Please note that a country-speci c adapter may be
necessary.
• Ensure that your notebook requires a supply voltage of
12 V / 14 V / 15 V / 16 V / 18 V / 18.5 V / 19 V / 19.5 V /
20 V / 21 V / 22 V (+/- 1 Volt).
• You can nd this information on the original power
supply unit or in your terminal device's operating
manual. If necessary, ask the dealer who supplied
your terminal device or contact your terminal device
manufacturer's support service.
• Set the voltage selector switch to the voltage required by
your terminal device.
Warning
• Do not use the universal notebook power supply unit if
you are unable to de nitively determine your terminal
device's supply voltage.
• Do not change the voltage again during operation of
the power supply unit in combination with a terminal
device.
• Ensure that the notebook's total power consumption
does not exceed the power supply unit's rated output
of 90 W.
• Failure to comply with this may cause damage to
the universal notebook power supply unit and the
connected terminal device!