Use - Casselin CCAP9 Handbuch

In case of improper installation, the device can be dangerous and cause injury. Before installation, check
EN
the power system data. Connect the device only when there is compliance. The unit should be unpacked
and checked fully before connecting by a professional.

5.2 Use

WARNING
The establishment of the installation of the device and maintenance must be performed only by professionals.
• Do not leave the unit without monitor.
• During use, your hands should be dry.
• Do not move or tilt the device during operation.
MANUAL
COMMISSIONING
The unit must be completely removed from its packaging. All guards must be fully
withdrawn.
Place on a solid, flat surface.
Once the pasta cooker was set up, see the international standards and regulations. Connect the water pipes,
make sure that the input, output and overflow water are positioned correctly according to the markings.
Crafting the overflow valve, close the outlet valve.
USE
Craft water entry, make sure that the water pipe is in the position of the holes overflow. The water is about
9L.
Connect the device, turn it on. Turn the energy regulator knob to maximum, the red LED lights up, the element
begins to work.
When the water boils, put the pasta in the basket and cook.
After cooking, turn the energy regulator knob to the minimum position for the next firing; when not in use, turn
off the energy regulator, turn off the device.
Warning: the water must be above items.
SECURITY
Do not fill too much water in the water tray, the machine was installed with a thermal cut-out to prevent
overheating or damage to the item.
If the power cord is damaged, it must be replaced by a qualified technician.
NOTE
The device has a security system in case of overheating. Upon activation, disconnect the device and allow it
to cool. If this protection system will start regularly, it is imperative to contact your dealer.
After automatic shutdown, the unit may be commissioned only by pressing the reset button on the unit's back
for this, wait until the temperature drops, press the Reset button.