Cable Connection - PROLUMIA 4001030040010300 Anleitung

SELECTABLE OUTPUT BRIGHTNESS
There are two choices of output brightness by different setting on the surface of the LED light engine:
ON - 100% (standard)
1 - 50%
The switch can be found next to the LED module and can be
seen when you have removed the diffuser.
MOUNTING
1. Disassemble the diffuser and LED panel.
2. Pull the power cord through the gasket.
3. Fix the fixture on the surface with screws.
(Pay attention to the direction. This is indicated by the "UP" marking on the base of the fixture.)
4. Connect the power cord on the terminal correctly.
5. Assemble the LED panel and diffuser.
4

Cable connection

MAINS POWER SUPPLY
Remove in Master/Slave use
Without sensor
14
MAINS POWER SUPPLY
With sensor
(switched phase not required)
www.prolumia.com
Output Output
Brightness Brightness
Rubber
Metal