Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Grinding & Cut-o
Grinding discs should be a minimum of 3.9mm thickness and rated to a minimum of 11,000 RPM.
Cut-o discs should be a minimum of 1mm thickness and rated to a minimum of 11,000 RPM.
• Always select and use discs that are recommended for the material to be ground/cut.
• Secure all work before beginning the operation.
• Secure small workpieces in a vice or clamp to a workbench.
• For maximum control, hold the grinder in front and away from you with both hands, keeping the grinding disc clear of the
workpiece. Start your grinder and let the motor reach full speed. Gradually lower the grinder until the grinding disc contacts
the workpiece.
• Use just enough pressure to keep the grinder from vibrating or bouncing.
• Use light pressure when grinding jagged edges or loose bolts where there is potential for the grinder to snag on the metal
edge causing kickback.
• Lift the grinder away from the workpiece before turning it OFF.
Product Speci cations
Power Rating
Power Consumption
Speed
Maximum Disc Diameter
Minimum Disc Thickness (Grinding)
Minimum Disc Thickness (Cut-Off )
Weight
230-240V
850W
11,000 RPM
125mm
3.9mm
1mm
2.2KG
Werbung
Inhaltsverzeichnis
