Cleaning & Maintenance - HoMedics AP-T30-EU Bedienungsanleitung

CLEANING & MAINTENANCE
CLEANING THE PRE-FILTER
NOTE: For best performance,
vacuum the pre-filter once a
month under normal usage.
1. Unplug the air purifier.
2. Remove the True HEPA-type
filter as described in the
Replacing the True HEPA filter
section.
3. Vacuum the outside of the
True HEPA filter using the brush attachment of your vacuum
cleaner, cleaning it thoroughly.
4. Place the True HEPA filter back into the air purifier and close
grille.
5. Plug the power cord into a standard AC outlet.
TO CLEAN THE OIL TRAY
Open the oil tray and remove the
pad. Essential oil pads should be
changed when switching to a
different essential oil scent. If
continuing to use the same scent,
set the essential oil pad aside for
reuse. Wipe down the inside of
the oil tray with a soft cloth. Place the essential oil pad back in the
tray and close.
NOTE: Leave the essential oil pad out of the oil tray when storing.
TROUBLESHOOTING
PROBLEM
Unit will not operate
Reduced airflow
Reduced odour removal
Excessive noise
Replace filter light remains lit
after filter replacement
Display lights are off
FOR BEST PERFORMANCE
• NEVER use water or any household cleaners or detergents to
• Clean off the outside of the unit with a dry cloth as needed.
• NEVER use water, wax, polish, or any chemical solution to clean
• Clean off the grille cover using a damp cloth or the brush
• Vacuum the pre-filter monthly under normal usage conditions.
• Replace the True HEPA filter every 12 months under normal
• Always use a genuine HoMedics replacement filter for optimal
To purchase genuine HoMedics replacement/spare parts please
visit www.homedics.co.uk
3 Pack of aroma pads - ARM-PAD3
Aroma tray - AP-T30WTARM
HEPA filter - AP-T30FL
UV-C Bulb – AP-UVC1
Cover & screws - APUVCCV
POSSIBLE CAUSE
• Unit is not plugged in
• Power button not pressed
• No power to unit
• True HEPA filter is not installed correctly
• Grille cover is not installed correctly
• The back grille may be blocked
• Pre-filter needs vacuuming
• The True HEPA filter needs to be replaced
• The True HEPA filter needs to be replaced
• The unit is not level
• The replace filter indicator needs to be
reset
• Nightlight setting
I
GB 5
clean the True HEPA filter.
the outside of the unit.
attachment of your vacuum as needed.
usage conditions.
performance.
• Plug unit in
• Press the power button to turn the power on
• Check fuses, try a different outlet
• Reinstall the True HEPA filter
• Reinstall the grille cover
• Check to make sure nothing is blocking the back
grille and air outlet
• Vacuum the pre-filter with the brush
attachment of your vacuum cleaner
• Replace the True HEPA filter
• Replace the True HEPA filter
• Place the unit on a flat, level surface
• Press and hold the ioniser button for 3 seconds
until the replace filter light turns off
• Press the nightlight button until the desired
lights are on/off
SOLUTION