Werbung
1. REMOVE THE THREE PRE-ASSEMBLED RODS FROM THE PACKAGE AND POSITION THEM AS
SHOWN IN FIGURE 1. ALL THE NOTCHES FOR THE HOOKS SHOULD FACE OUTWARDS.
2. INSTALL THE REMAINING RODS SO THAT THE NUMBERS ON THEM ARE TOGETHER (3 AGAINST 3,
4 AGAINST 4 ETC.). IMPORTANT: KEEP TO THE CORRECT NUMERICAL ORDER.
TIGHTEN THE SCREWS ONLY SLIGHTLY AT FIRST.
THE HOOK CUTOUTS ALWAYS FACE OUTWARDS AND UPWARDS.
THE HOLE SPACING CAN BE VARIED BY PULLING THE PRE-ASSEMBLED RODS APART OR PUSHING
THEM TOGETHER. MAKE SURE THAT THE SURFACES OF THE RODS TOUCH EACH OTHER.
3. AFTER ALL THE PARTS HAVE BEEN CONNECTED TOGETHER, TIGHTEN ALL THE SCREWS FIRMLY.
Stab, Länge ca. 50 cm
Rod, length 50 cm
6 – 6
5 – 5
Werbung
