Inhaltsverzeichnis
Werbung
Before the first use
Before you use it for the first time, remove the packing materials, unwind the power cord completely. Make
sure that all parts of the device are not damaged.
- Turn around the oil radiator
- Place the wheel bar on the outer sections.
- Fasten the wheels to the radiator using the washers and tighten the screw (Fig.2)
- Return the device to a vertical position.
The heater should not be closer than 90 cm from furniture, curtains and other interior items.
Before connection the plug to the mains make sure that the device switch is set into «O»- «OFF» position.
ATTENTION!
When switched on for the first time a slight odor might be emitted for a few minutes. This is harmless
and occurs with most heaters when any slight traces of dust or lubricants that may have collected in
the factory are heated away.
Thermostat (1/ Fig.1) allows you to adjust and maintain the room temperature
"-"(thin end of mark) the minimum room air temperature
"+" (thick end of mark) the maximum room air temperature
Select the desired power mode (2/Fig1):
I - the first power level 800 W
II - the second power level 1200 W
III – the third power level 2000 W
6
Operation
Werbung
Inhaltsverzeichnis
