Operation; Powering Up Light Source; Light Brightness Display And Control; Lamp Life Hours Display - Cuda surgical ELITE 300 Bedienungsanleitung

6. OPERATION

6.1 POWERING UP THE LIGHT SOURCE
To operate the light source: Attach the instrument or headlamp to the light source. Turn on
the power switch. The fan will start. The indicator on power switch will light.

6.2 LIGHT BRIGHTNESS DISPLAY AND CONTROL

The light brightness adjustment enables the user to obtain a brighter or darker illumination
of the object of observation.
Adjust the light intensity by turning the intensity control knob.

6.3 LAMP LIFE HOURS DISPLAY

The hour meter shows the total elapsed running time of the unit. Record the hours when
replacing the lamp.

7. CLEANING

NOTE Always disconnect the power cord before cleaning.
The light source can be cleaned with any cleaning agents, which are used for external
cleaning of electric equipment, according to instructions given by the manufacturer of the
cleaning solution.
Do not allow excessive moisture or liquids to come in direct contact with the light source.
Do not use cleaning agents that are not permitted for use with plastics, i.e., ammonia,
acetone, salty acids (HCl), etc.
Do not allow cleaning agents or liquids to enter the control unit outlets or vents at side, back
or bottom of the unit.

8. DISINFECTION

8.1 DISINFECTING THE LIGHT SOURCE
NOTE Always disconnect the power cord before cleaning.
Use any disinfectant agents which are commonly applied while disinfecting surfaces of
electric medical equipment. Such disinfectant agents usually arrive in the form of sprays or
damp cloths.
Follow the instructions given by the manufacturer of the disinfectant solution.
®
LIT037 CUDA SURGICAL ELITE 300
(English)
Rev. M
Date of Revision:05/14/14
Page 9 of 60