Eibenstock MXT 110 C Originalbetriebsanleitung Seite 11

Modifications of the tool are prohibited.
When the machine runs outside, always use a protection switch (30 mA
max.) against fault current.
The machine should only run under supervision of somebody.
Pull the plug and switch the machine off if it is not under supervision, e.
g. in case of setting up and stripping down the machine, in case of
voltage drop or when fixing or mounting an accessory.
Switch the machine off if it stops for whatever reason. This way, you
avoid that it starts suddenly and not under supervision.
Always lead the cable to the back, away from the machine.
Do not use the machine if a part of the housing is damaged or in case
of damages on the switch, the connection cable or plug.
Power tools have to be inspected by a specialist in regular intervals.
Keep the handles dry, clean and free of oil and grease.
Do not touch rotating parts.
Be careful with long hair. Only work with close-fitting clothes.
Persons under 16 years of age are not allowed to use the machine.
When working with this machine wear ear protectors, goggles and
protective gloves.
During use, always hold the machine with both hands and
maintain a safe standing position. Pay attention to the reaction
moment of the machine.
For further safety instructions, please refer to the enclosure.
Before starting the machine check the correspondence between voltage
and frequency according to the data mentioned on the identification plate.
Voltage differences from + 6 % and – 10 % are allowed.
The mixer is made in protection class II. Only use extension cables with a
sufficient cross-section. A cross-section which is too small could lead to an
excessive power loss and to an overheating of motor and cable.
Tool Change
Attention!
Before any work on the tool, disconnect the plug from the mains!
Electrical Connection
11