Product Setup; Easy Setup; Connect The Ethernet Cable - D-Link DAP-1360 Installationsanleitung

PRODUCT
SETUP

EASY SETUP

Login
DAP-1360
CONNECT THE POWER ADAPTER AND ANTENNAS
Check the AC voltage of your AC power outlet against the AC power
input of the power adapter. Connect the power adapter supplied with
the DAP-1360 to the power socket on the back of this device first,
then plug it to your AC power outlet. Check to see that the Power
LED on the front panel of the DAP-1360 is turned ON. Connect both
antennas to the antenna connectors on the back of the DAP-1360.
WARNING! The DAP-1360's power output is 12 volts DC, 0.5
Ampere. Use only the power adapter supplied with this DAP-1360 or
one with the same power specifications. Using a power adapter with
a different voltage or plugging your DAP-1360 to a wrong AC voltage
outlet will damage this device and will void the warranty for this
product.

CONNECT THE ETHERNET CABLE

Connect one end of the Ethernet cable to the LAN port on the
back panel of the DAP-1360, and the other end of this cable to
your computer's Ethernet port. If your computer is connected to
an Ethernet network via an Ethernet switch, connect this end of
the cable to the switch's port.
CONFIGURE THE DAP-1360
Open a web browser and go to http://dlinkap. Enter admin as
the User name, and leave the Password blank. Now you can
use the Setup Wizard to configure your DAP-1360.
(The setup wizard only support Access Point/Wireless Client/
Repeater mode, please refer user manual to configure your
DAP-1360 for different operation mode)
5