AEG SCB61826NS Benutzerinformation Seite 26

26 www.aeg.com
Problem
The appliance is noisy.
The lamp does not work.
The lamp does not work.
The compressor operates
continually.
There is too much frost and
ice.
The compressor does not
start immediately after
pressing the FROSTMATIC,
or after changing the tem-
perature.
Water flows on the rear
plate of the refrigerator.
Water flows inside the refrig-
erator.
Possible cause
There is no voltage in the
mains socket.
The appliance is not sup-
ported properly.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor-
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor-
rectly.
The FROSTMATIC is
switched on.
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
This is normal, no error has
occurred.
During the automatic de-
frosting process, frost
melts on the rear plate.
The water outlet is clog-
ged.
Food products prevent
that water flows into the
water collector.
Solution
Connect a different electrical
appliance to the mains socket.
Contact a qualified electrician.
Check if the appliance stands
stable.
Close and open the door.
Contact the nearest Author-
ised Service Centre.
Refer to "Operation".
Wait some hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "Closing the door".
Refer to "FROSTMATIC func-
tion".
Refer to "Closing the door".
The compressor starts after a
period of time.
This is correct.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.