Powering On / Off - Anker PowerConf Bedienungsanleitung

Press
Flashes blue
Steady blue
Each time you power on the product, it will automatically connect with
•
the last successfully connected device if available.
When the speakerphone is connected to two devices via USB and
•
Bluetooth at the same time, press and hold the multi-function button for
two seconds to switch between Bluetooth and USB modes.
To disconnect Bluetooth, press the Bluetooth button again.
•

Powering On / Off

Press and hold the power button for two seconds to power on. The LED light
will turn on, run clockwise, and then fade out. To power off, press and hold
the power button for two seconds.
Enter Bluetooth pairing mode
Bluetooth pairing
Bluetooth connected
EN 03