Programming Buttons; Declaration Of Conformity - nedis ZBWS40WT Kurzanleitung

The app asks if the product is in pairing mode. LED light A
pairing mode is active.
3. Press LED already Blink if A
If A is not blinking, press and hold button A
5
4
the pairing mode manually.
After a few seconds, the product appears on the interface.
4. Rename the product by tapping above the current name.
5. Tap Done to confirm and save the connection.

Programming buttons

The product has three commands: single tap, double tap and long press. Each
command can be assigned to a different action for a linked Nedis SmartLife
product.
1. Open the Nedis Smartlife app on your phone.
2. Tap Smart scenes at the bottom of the home screen.
3. Tap Automation to open the automation interface.
4. Tap + in the top right corner.
5. Choose one of the commands in the app under Condition.
6. Specify what you want the command to do with a linked Nedis SmartLife
product.
7. Tap Save.
Removing the product from the app
1. Open the Smart Button interface in the app.
2. Tap the pencil icon in the top right corner.
3. Tap Remove Device.

Declaration of Conformity

We, NEDIS, as manufacturer, declare that product ZBWS40WT from the brand
Nedis, produced in China was tested according to all relevant CE standards /
regulations and passed all tests.
The complete Declaration of Conformity ( + safety datasheet if applicable ) can
be found and downloaded via http://webshop.nedis.com
For other compliant-related information, please contact customer service desk
for support:
is blinking.
5
6
blinks to indicate
5
3 for 10 seconds to activate