Monacor WALL-05DTM/WS Bedienungsanleitung Seite 11

have once been connected can be changed by
software at any time . In the Dante network,
devices configured as transmitters are used as
signal sources . By means of the program "Dante
Virtual Soundcard" from the company Audinate,
computers can also be used as signal sources,
e . g . to feed audio files replayed on the com-
puter to the Dante network .
The speaker WALL-05DTM is equipped
with one Dante receiving channel . The receiving
channel is assigned to any transmitting channel
in the Dante network via the Dante configura-
tion program "Dante Controller" (
Dante is a trademark of Audinate Pty Ltd.
®
4 Installation
The speaker is designed for being installed on a
wall, but it can also be set up on its own .
To install the speaker:
1) Remove the plastic support (4) from the metal
bracket (3) . Then use two screws to fasten
the support at the desired location (e . g . wall
or ceiling) .
2) Fasten the metal bracket (3) to the plastic
support, using the two recessed head screws
of the bracket . Use the holes in the metal
bracket which are most suitable for the de-
sired speaker alignment .
3) Use the screws (2) to fasten the speaker (1)
to the metal bracket . Align the speaker to
the desired sound zone before fastening the
screws .
4.1 Network
To feed in audio signals via a Dante network,
connect the jack IN PoE (5) to an individual com-
puter, a local computer network or (via a router,
for example) to a large computer network . For
correct configuration, knowledge of network
technology is indispensable . The speaker can be
supplied with power via the same connection
☞
jack ( chapter 4 .2) .
For integration into a Dante network, the
speaker must be connected to an Ethernet
switch that supports at least Fast Ethernet (trans-
mission rate 100 Mbit /s) .
The interface of the speaker is preset to au-
tomatic address assignment; configuration via
the program "Dante Controller" is possible
☞
(
The jack LINK (6) can be used for routing the net-
work connection, e . g . directly to an additional
WALL-05DTM . The PoE power supply, however,
is not routed via this jack .
4.2 Power supply
Power supply can be made via the network con-
nection (Power over Ethernet): Connect the jack
☞
chapter 5) .
IN PoE (5) to a network connection providing
PoE (e . g . PoE switch) . If power supply via PoE
is not possible or if a higher output power is
required, use a DC power connector with the
dimensions 5 .5 / 2 .5 mm (outside / inside diam-
eter) to connect a regulated 19 V DC power
supply unit with a permanent rating of 2 .5 A to
the jack 19 V ⎓ (7) . Observe the correct polarity:
inside contact = + .
Lower supply voltages are also possible, resulting
in a corresponding reduction of the amplifier
power that can be achieved .
chapter 5 .1) .
supply voltage
19 V
15 V
12 V
9 V
PoE
nominal power
30 W
21 W
15 W
8 W
20 W
11