Watch videos and photos
Tip: You can adjust the camera to the desired angle.
Preparation of the controller
1. Insert and tighten the antenna to the antenna hole on the controller as illustrated.
2. Use a Phillips screwdriver to open the battery compartment cover. Insert 3 x AA batteries with the correct polarity and replace
the battery compartment cover.
Battery compartment
Charging the helicopter
Move the ON/OFF switch on the helicopter to OFF. Insert the charging plug of
the charger into the charging socket on the helicopter. Connect the charger
with a power socket - the red charge LED will light up. The charge LED will
extinguish after max. 120 minutes to indicate the helicopter has been
completely charged.
Flying the helicopter
X
X
Make yourself familiar with the opration of your transmitter before flying the helicopter for the first time.
X
X
Please practise and repeat flight simulations with your transmitter before you take off for your first real flight.
X
X
Move the ON/OFF switch on the remote controller to ON. The power LED will light up.
X
X
Move the ON/OFF switch on the helicopter to ON.
X
X
Put the helicopter onto an even surface. The tail unit should point to you.
All manuals and user guides at all-guides.com
2 possibilities of access to data:
1) Remove the microSD card from the camera and insert the
card into the USB stick. Now insert the UBS stick into a USB
port on your computer and enjoy your videos and photos.
2) Connect the helicopter directly to the computer USB
port by using a USB cable.
Battery compartment cover
3 x AA batteries
Off position
12
Flight altitude
The throttle stick controls the height of the model. Push the
stick forward: the model will gain height. Pull the stick back:
the model will sink down and land.
Flight direction
The control stick controls the flight direction of the model.
Push the stick to the left: the model will fly to the left.
Push the stick to the right: the model will fly to the right.
Push the stick forwards: the model will fly forwards. Pull
the stick back: the model will fly backwards.
Switch to expert mode to fly the helicopter faster and
more agile.
Trim the helicopter
Trimming the helicopter may be required to achieve a
straight flight path.
Helicopter flies to the right (clockwise) without control
input: turn the trim button to the left until the model flies
straight.
Helicopter flies to the left (counterclockwise) without
control input: push the trim button to the right until the
model flies straight.
Illumination
Push the light button to switch the LEDs on and off.
13