Milly Mally MAX Gebrauchsanleitung Seite 5

Thank you for purchase of MILLY MALLY
EN
This booklet will provide you with the correct method of use and the
easiest method of assembly. It will also guide you as to how to avoid
incorrect method of operation. Please retain this booklet. Should you
have any questions about your high chair or experience any di culties,
Please contact the retailer from which you purchased the product. Your
local retailer is in best position to promptly address any requirements.
IMPORTANT, KEEP THIS MANUAL
FOR FUTURE USE!
ASSEMBLY INSTRUCTION
FABRIC UPHOLSTERY
1) Cover the backrest with the fabric cover.
2) Place and tighten the nut that joins the backrest to the base of the seat.
3) Pass the crotch strap trough the openning in the fabric upholstery, place
the safety belt.
ASSEMBLY OF THE CHAIR
1) Screw on the back to the seat.
2) Screw on the 2 crossbars to one of the sides.
3) Position the seat and the back inserting the pivots into the corresponding
grooves. Position the other side and screw in the 4 screws.
RECLINING CHAIR INSTRUCTIONS
1) To change the position of the back, press the handle in the direction of
the arrow.
ASSEMBLY OF THE TABLE
1) Join to the left-hand side, the table, the two crossbars, the footrest (1-5)
2) Right-hand side, placing the screws in the order indicated
in the accompanying diagram (6-10).
TO REMOVE THE SEAT
1) Press the buttons on the front legs while pushing the chair upwards.
product.
WARNING
1) Adult assembly required.
2) Do not use the highchair until you baby can not sit alone
3) Never use near stair, re, swimming pools or any other areas
4) Do not leave child unattended
5) Not to use the highchair until all its parts are not properly
6) Use this product only as described in the instructions.
7) You should make sure the harness is properly adjusted
8) Do not use the convertible high chair if any of the parts
9) Only use the spare pieces that are supplied by the retailer.
10) Do not set highchair in close proximity to open ames
that are not safe.
aligned and adjusted
are missing or broken.
and other sources of excessive heat such as radiators,
electric heating rods, gas heaters, etc.