Energeeks Observer II Kurzanleitung Zur Installation Seite 19

•
Enter the password for the Wi-Fi network and click on 'Next'.
•
"Show the camera the QR code that appears on the screen.
Place the mobile phone a few cm from the lens and slowly
move it away to a distance of about 30 - 40 cm. Repeat the
process zooming in and out of the code to the camera. "
•
Once the camera recognizes it, it will confirm with a beep.
•
At this time click on 'Confirmation sound'. The installation will
finish automatically and the camera will start.
•
If the camera does not read the QR code, please reset the
camera by pressing the reset button for a few seconds until
you hear a 'beep' and repeat the process.
Connection failure: If after reading the QR code, the installation
process fails, make sure that the Wi-Fi network is 2.4Ghz, that the
password is correct. Please restart the camera and try again.
Some fiber optic routers have an inappropriate configuration for this
system, if after following these steps the camera does not connect,
contact our technical service, who will advise you to configure it
correctly, or your internet service provider.
Some fiber optic routers have an inappropriate configuration for this
system, if after following these steps the camera does not connect,
contact our technical service, who will advise you to configure it
correctly.
19