REMOTE CONTROL
These jack are for use with the enclosed remote
control. Only the low pass signal will be
controlled.
POWER - LED
It indicates amplifier has turn
on signal
OUTPUT
Provides a full range line level
(RCA) output that allows the use of
additional amplifiers
INPUT
LEVEL
Accepts line level (RCA) inputs from
0.2 to 6 Volts
PROTECT - LED
It indicates the fault operation of the amplifier. When the fault
conditions (overload, excessive heat or short circuit of
speaker) arise, the protection curcuit is engaged to protect
both the speakers and the amplifier against damage
10
Amplifier - Features
SUBSONIC
The Subsonic filter sets the lower cut-off frequency and
protects the Subwoofer from damage. The subsonic
frequency is fully variable from 15Hz to 55Hz
INPUT
This allows you to match the
amplifier input sensitivity to
the output level of the source
(head unit)
LOWPASS
The lowpass filter eliminates the higher
frequencies. The built in low pass filter is fully
variable from 40Hz to 4000Hz (4kHz), with a
rolloff of 12dB/octave
BASS BOOST
Allows you to adjust the bass
boost from 0dB up to 12dB