Sealife SL052 Bedienungsanleitung

Micro Underwater Wide Angle Dome Lens (Item SL052)
1) Overview: The Micro UW Wide Angle Dome Lens is designed for the SeaLife Micro-series and ReefMaster RM-4K
underwater cameras. It is a precision optical lens that allows you to get 3X closer to the subject and increases the
camera's native field of view by 43%. The lens can be attached/removed while underwater.
2) What's in the box:
Wide Angle Dome Lens
(with Lens Adapter attached)
3a) Mounting the lens to SeaLife Micro-series UW camera:
Push lens on camera lens port with
Locking Ring in unlocked position
3b) Mounting the lens to ReefMaster RM-4K UW camera:
Follow instruction in step 3a making sure that the camera
Lens port slot is located between the lens adapter fingers
Lens with dome and rear lens covers attached
Lens inside lens pouch
7) Guarantee:
SeaLife warrants the original purchaser of this product, for a period of one (1) year from the date of purchase, that the product is
free from defects in workmanship and materials. In the event the original purchaser believes there is a defect in a product, it is recommended that the
purchaser first visit www.sealife-cameras.com for product updates and information on how to get warranty repair service. Please contact your local
SeaLife dealer or the importer in the country where the product was purchased for return information.
SeaLife (Div. of Pioneer Research), 97 Foster Road, Moorestown, NJ 08057 USA
Neoprene lens pouch
and dome lens cover
Slide Locking Ring down to
locked position
5) Important:
a) Attach the dome lens cover and rear lens cover when lens is in the rinse
bucket to prevent scratches.
b) When entering the water, remove the lens from the camera to get rid of any
trapped air. There must be water between the lens and the camera port.
c) After each dive, soak the lens in fresh water for about 20 minutes to remove
any residual salt, sand and dirt. Dry lens with clean cotton towel so water
drops do not dry and stain on the lens.
d) Make sure the neoprene lens cover is free of sand/dirt/debris before
attaching it to the lens or it may cause scratches.
e) If necessary, rotate the lens hood so it does not appear in the corners of the
picture.
f) The dome lens has a hard coating applied to prevent scratches; however,
proper lens cleaning care is required. Brush or blow away and
sand/dirt/debris from the lens surface. Use lens cleaning cloth provided to
gently clean fingerprints and smudges from the lens. Moisten lens cloth with
lens cleaner or fresh water if necessary – never use detergents or chemicals
to clean the lens.
Rear lens Lanyard
cover
4) Attaching the lanyard:
Insert looped end of lanyard through hole on side of the lens adapter
Feed the other end of lanyard through looped end and tighten.
Attach other end of lanyard to the camera's lanyard hole. The lanyard
can be separated by pushing the release lever on the center connector
www.sealife-cameras.com
Instruction Sheet
Micro fiber
cleaning cloth
(February 2018)