Safety And Installation Instructions - Waeco PerfectView GPS300 Montage- Und Bedienungsanleitung

_GPS300.book Seite 15 Freitag, 17. Juli 2009 5:07 17
PerfectView GPS300
2

Safety and installation instructions

Please observe the prescribed safety instructions and stipulations from the vehicle
manufacturer and service workshops.
The manufacturer will not be held liable for claims for damage resulting from the following:
Faulty assembly or connection
Damage to the appliance resulting from mechanical influences and excess voltage
Alterations to the device without express permission from the manufacturer
Use for purposes other than those described in the operating manual
Warning
e
To prevent the risk of short circuits, always disconnect the negative terminal of
the electrical system before working on the vehicle.
If the vehicle has an additional battery, its negative terminal should also be dis-
connected.
Warning
e
Inadequate supply cable connections could result in short circuits, causing:
– Cable fires
– The airbag being triggered
– Damage to electronic control equipment
– Electrical malfunctions (indicators, brake light, horn, ignition, lights)
Therefore, please observe the following instructions:
When working on the following cables, only use insulated cable terminals, plugs and
flat sockets:
– 30 (direct supply from positive battery terminal)
– 15 (connected positive terminal, behind the battery)
– 31 (return cable from the battery, earth)
Do not use terminal strips.
When the negative terminal of the battery is disconnected, all data stored in the volatile
memory will be lost.
The following data must be reset, depending on the vehicle equipment options:
– Radio code
– Vehicle clock
– Timer
– On-board computer
– Seat position
You can find instructions for making these settings in the corresponding operating
manual.
Safety and installation instructions
15