Syntrox WK-25L-8-2 Bedienungsanleitung Seite 8

Before cleaning the wine cooler, make sure it is unplugged. Never clean the unit with an acid
●
preparation, medical, dilution, gasoline, oil or any other kind of chemical substance that could
damage the refrigerator.
Repair should only be made by authorized service centers.
●
Caution：
1. To reduce the risk of fire, replace only with same type fuse.
2. Free standing installation only.
3. Do not use extension cords.
Warning:
1. If the supply cord is damaged, it must be replaced by a qualified person in order to avoid
hazard.
2. Please screw off the door before throwing it away.
3. Please keep the appliance away from any flammable substances.
4. To avoid a hazard due to the instability of the appliance, it must be fixed according to the
instructions.
5. Do not use electrical appliances inside the food storage compartments of the appliance.
6. This appliance is not intended for use by persons (including children) with reduced physical,
7. Children should be supervised to ensure that they do not play with the appliance.
8. This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
9. Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of
obstruction.
OPERATION OF REFRIGERATOR
Clean the inside before use.
Fix the shelves properly according to the instruction.
When first time use (or haven't used it for a long time), you should adjust the temperature to
minimum and have the cabinet empty running for 2 hours, and then put your wine in it and
adjust the desired temperature.
When the power is connected, cooling system starts to work. The TEMP-ADJ button is set on
certain position, which means that if the temperature in the wine cooler reaches the point set,
Self-control Temperature System stops cooling system so the temperature in the cabinet rises
gradually.
When the inside temperature rises above the set point, Cooling Self-control Temperature
starts to work again, the cellar enter into cooling circles.
When you want to change the temperature in the cabinet, You can push "Temp +" and" Temp
–" to increase and decrease the temperature.
You can push the "C/F" button to switch between Celsius and Fahrenheit or push the "Lamp"
button to control the light inside.
NOTE: After you have set the temperature, the LED display will return to show the
temperature in the cooler, but it could turn to the point that you have set gradually.
2