Montageanleitung / Assembly instructions
Han-Yellock
30 Trägergehäuse / Carrier hood
®
Montage / Assembly
anschlussseitig /
termination side
Module / Modules
①
②
Adapterrahmen /
Adapter frame
①
Bestell-Nummer 11 12 300 0110/9901
Stand: Oktober 2021
MA_Han-Yellock_30_Traegergehaeuse_11 12 600 0110 _9901.indd
① Setzen Sie das Modul in Position
„A" ein.
▸ Das Modul rastet mit hörbarem
Klicken ein. /
Insert the module into the „A"
position.
▸ The module snaps into position
with an audible click.
② Modul an Endposition schieben.
Push the module into its final
position.
Hinweis:
Die Steckplätze müssen immer
komplett bestückt werden! /
Notice:
The slots must be filled
completely!
Blockierfunktion (nur 11 12 300 0110)
Schlitz senkrecht:
Schlitz waagerecht:
Locking function (11 12 300 0110 only)
slot vertical:
slot horizontal:
① Beachten Sie die Ausrichtung der
seitlichen Kunststoffnasen!
Diese Kunststoffnasen werden in
die Metallklammer des Gehäuses
gedrückt.
▸ Der Adapterrahmen rastet mit
hörbarem Klicken ein. /
Note the orientation of the lateral
plastic tabs!
These plastic tabs are pressed
into the metal clamp of the hood/
housing.
▸ The adapter frame snaps into
position with an audible click.
Module / Modules
/
offen
verriegelt /
open
locked
steckseitig /
mating side
①
②
Adapterrahmen /
Adapter frame
①