Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Step 2:
Fix the long supports on to the frame of the solar panel
Step 3:
Mount the short supports on the surface using the rubber pads and screw set provided
Step 4:
Adjust the length of the long supports depending on the chosen angle of the solar panel.
Mount the long supports to the surface using the rubber pads and screw set provided.
Take extra care when fixing the base of each long support, as their position in relation to
the short supports will determine the range of the solar panel tilting angle:
- for large (steep) tilt angles of the solar panel, position the
bases of the long supports closer to the bases of the short
supports
- for small (shallow) tilt angles of the solar panel, the bases of
the long supports should be positioned further away from the
bases of the short supports
Step 5:
Ensure that all screws and nuts are fastened tightly to secure the system in
place.
about us
Contact
Offgridtec GmbH
Tel +49 8721 91994-00
Im Gewerbepark11
Mail info@offgridtec.com
84307 Eggenfelden
Onlineshop
www.offgridtec.com
Werbung
