Maintenance; Environmental Protection - Worx Professional WU430 Bedienungsanleitung

Working hints for your circular
saw
If your power tool becomes too hot, pls run your circular saw no load
for 2-3 minutes to cool the motor. Avoid prolonged usage at very low
speeds.
Always use a blade suited to the material and material thickness to
be cut. The quality of cut will improve as the number of blade teeth
increase. Always ensure the work-piece is firmly held or clamped to
prevent movement. Support large panels close to the cut line. Any
movement of the material may affect the quality of the cut. The blade
cuts on the upward stroke and may chip the uppermost surface or
edges of your work piece. When cutting, ensure your uppermost
surface is a non-visible surface when your work is finished. Feeding
too fast significantly reduces the performance of the machine and
shortens the life of the saw blade. Always face the good side of the
work piece down to ensure minimum splintering. Only use sharp saw
blades of the correct type.
Pocket cutting (soft materials only) This operation requires much skill
with a saw and must only be carried out by a competent person.
Warning: The blade teeth are exposed during this operation so
proceed with extreme caution.
Clearly mark the area to be cut. Set the depth of cut on the saw.
Position the saw over the
marked area with the front edge of the base plate resting on the work
surface and cutting guide aligned with marked line on workpiece
(See J.1 and J.2). Ensure the blade is not touching but is close to
the work surface. The moving lower guard must be rotated open by
using lever (5). Switch the saw on and gently swing the blade down
All manuals and user guides at all-guides.com
11
into the material but maintain a pivoting force on the front edge of the
base. The moving lower guard can now be released for normal action
of the guard.

Maintenance

Remove the plug from the socket before carrying out any
adjustment, servicing or maintenance.
Your tool requires no additional lubrication or maintenance. There are
no user serviceable parts in your tool. Never use water or chemical
cleaners to clean your tool. Wipe clean with a dry cloth. Always
store your tool in a dry place. Keep the motor ventilation slots clean.
Occasionally you may see sparks through the ventilation slots. This is
normal and will not damage your power tool.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in order
to avoid a hazard.

Environmental protection

Waste electrical products should not be disposed of with
household waste. Please recycle where facilities exist. Check
with your local authorities or retailer for recycling advice.