General Warnings - GET RX1 PRO Installationsanleitungen

ENGLISH
A. WARNINGS FOR CORRECT USE
Read all the instructions and warnings carefully before using
the GET RX1 PRO ECUs. Failure to read and/or observe the
instructions and warnings can lead to incorrect use of the device or
its malfunction, resulting in product damage and personal injuries.
RX1 PRO KIT IS INTENDED ONLY AND EXCLUSIVELY
FOR RACING USE.

GENERAL WARNINGS

1. Follow the instructions described in this manual to prevent
vehicle damages.
2. Do not modify or replace the material supplied by GET.
3. Always make sure that no installed part can interfere with the
hot parts of the engine, the steering components or with the rider.
4. The product is not a toy. Keep it out of the reach of children and/or
animals as it contains small sized components that could be swallowed.
5. Do not use the product for purposes other than those specified in
these instructions.
6. Do not use high pressure washers on the product.
SPECIFIC WARNINGS
1. Always make sure that RX1 PRO ECU is properly installed and
functional prior to use.
2. Never expose the device to temperatures above 70°C /158°F.
3. Install it when the engine is cold.
4. The RX1 PRO ECU may not work properly if the OEM TPS
sensor is damaged or modified.
5. The RPM limiter threshold of the RX1PRO maps is higher
than the standard ECU.
EN 2
6. To use and manage the GPA technology, it is necessary to install
GET GPA Switch or GET LC-GPA module (both sold separately), or
manage it with GET Maya Software (sold separately).
7. To change the RX1 Pro injection map, it is necessary to use
GET Maya programming software (sold separately).
8. If the bike does not start or the engine is irregular, be sure that the RX1
Pro ECU chosen is compatible with your bike model and year, verify that
the ECU is connected properly, and always perform a TPS calibration.
9. This ECU has been developed for bikes without power
restrictors. Remove them before installing GET ECU. This
manual contains some example of standard power restrictors:
please contact your bike dealer to get more details about your
bike power restrictors and where they are located.
10. OEM handlebar commands for map change and launch
control will not work after installing GET RX1 Pro ECU. To grant
proper functionality and reliability use only GET Map Switch
(included in the kit) and GET LC-GPA module (sold separately).
B. RX1 PRO SPECIFIC INSTALLATION
RX1 PRO is a fully programmable plug&play ECU. RX1 PRO is
the best solution both for original and modified engines: it is
possible to adjust the calibration map through both WiGET App,
by using the WiFi-COM device, and/or MAYA software.
WiGET App
RX1 Pro comes with 2 maps developed by GET R&D
Department, which can be easily switched thanks to the
Map Switch included in the kit.
3 EN