Herunterladen Inhalt Inhalt Diese Seite drucken

Key To Symbols; Range Of Application; General Advice; Installation Instructions - BETTE B57-0372 Montageanleitung

Dichtsystem badewanne
Inhaltsverzeichnis

Werbung

EN

Key to symbols

Cross reference to other products or
documentation
Spare part
Z0018427_MA_BETTEDichtsystem_Badewanne_2021_07.indd 3
Z0018427_MA_BETTEDichtsystem_Badewanne_2021_07.indd 3
Important information –
Please note!

Range of application

The sealing system provides reliable protection against
moisture penetration.
The sealing system is suitable for all Bette built-in bathtubs.
There are two different installation types:
– Tub edge height = 8 mm (folded edge – page 8)
– Tub edge height > 20 mm (page 12)

General advice

– These installation instructions must be available during the
entire installation work. If the installation work is carried out
by various people (e.g. plumber, tiler), they must all be given
a copy of these installation instructions.
– Installation can be carried out without a side wall, or with
a wall on one, two or three sides. The illustrations show
installation of the sealing system for a corner installation.
– Measurements are indicated in millimetres (mm).
– Figures are not true to scale
– Subject to technical modifications.

Installation instructions

– Installation should be done only by a qualified technician.
– The sealing material must seal the sides and corners of the
tub edge.
– Please exercise care when handing sealing material.
– No defects may be left in the sealing material.
– The adhesive joints have to be maintained clean, dry and
free of grease.
– The adhesive sealing strips create a very strong bond. They
have to be precisely positioned and applied properly.
– The sealing material can stretch in order to adjust to uneven
spots.
– When applying the sealing material please watch out for
recesses and notches.
– The sealing material has to be firmly pressed in place
around the adhesive joints to guarantee a permanent seal.
– The sealing material must be incorporated into the
compound seal.
– Large and small format tiling work should be performed
pursuant to DIN 18157.
Separate documents (e. g. for drain sets) should be
complied with.
3
08.07.21 11:08
08.07.21 11:08

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis