Outwell Sky2 Bedienungsanleitung Seite 3

UK: INSTRUCTION MANUAL
Warnings:
1. The pump must only be used with the AC/DC adaptor or cigarette lighter DC 12V cable supplied with
the pump.
2. This pump is intended to inflate items such as air mattresses, inflatable furniture etc. It's not designed
for use exceding 10 minutes. Extended operation can overheat and damage the pump.
3. Do not exceed 10 minutes of continuous operation.
4. Take a 20 minute break before assuming inflation. Carefully follow the instructions on
the item you are inflating. Never exceed the recommended pressures. Bursting items can
cause serious injury.
5. Never leave the air pump unattended while in use.
6. CAUTION: To reduce the risk of electric shock, do not expose the air pump to rain and
store it indoors. Do not use the air pump under wet conditions. Do not drop pump into
water or other liquids. Do not operate the pump with wet hands.
7. Never allow sand, small rocks etc. to be sucked into the inflation or deflation port while in use.
8. Never look into or point the inflate opening towards your eyes while pump is operating.
9. Never place your hand or fingers into the inflation or deflation opening at any time.
10. Never attempt to disassemble or close to the openings while the air pump is operating.
11. The supply cord on the power supply, cannot be replaced. If the cord is damaged the power supply
should be scrapped.
12. The sound pressure level is approximately 87 dB (A).
13. This appliance can be used by children from the age of 8 and people with reduced physical, sensory
or mental capabilities or lack of experience and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe way and understand the hazards involved.
Children shall not play with the appliance. Cleaning and user maintenance shall not be made by
children without supervision.
14. The supply cord of the AC/DC adaptor cannot be replaced. If the cord is damaged the AC/DC adaptor
should be scrapped.
15. If the 12V DC supply cord is damaged it must be replaced by a special cord available from Oase
Outdoors or its dealers.
16. Do not modify the product
Assembly and use of the pump:
The ON/OFF switch is marked with the symbols (I) and (O). (I) is the ON position.
Use with the AC/DC adaptor:
1a . Install the appropriate plug tip (7)&(8) on the AC/DC adaptor (6) by aligning the text "LOCK" on the
plug tip with the location of the release button (9), and rotate the plug tip in the direction of the arrow
next to the text "LOCK" until the plug tip locks into the AC/DC adaptor with an audible click. Check that
the plug tip is firmly connected to the AC/DC adaptor before using the adaptor.
1.b To remove the plug tip, press the release button (9) and rotate the plug tip in the direction of the
arrow next to the text "OPEN", until it can be removed.
1.c Plug the AC/DC adaptor into a suitable mains outlet, and plug the cord into the 12V connection socket
(3) on the pump unit (1).
Continue with point 3.
4 4
Use with the 12V cigarette lighter cord:
2. Connect the cord (5) to the 12V connection socket (3) on the pump unit (1), and to a suitable 12V DC
outlet.
3. Select a suitable nozzle (4) and attach it to the inflation port (11), or deflation port (10), depending on
whether you wish to inflate or deflate.
Attach the nozzle to the valve on the inflatable device, and press (I) on the switch. Pay special attention to
warnings #2 - #4.
When deflating it might be necessary to pinch the valve with your fingers, to open the flap inside the valve
to allow air to escape.
The pump can be cleaned with a damp rag. Allow the pump to dry completely before using again.
Do not use corrosive liquids to clean the pump.
Instruction for disassembly of pump for disposal of components when pump has
reached the end of its usable life:
1) Remove the nozzles (4). Dispose of the nozzles as plastic according to local regulations
2) Dispose of pump unit, AC/DC adaptor and 12V supply cord as electric waste according
to local regulations
Technical data pump:
12V 48W
Class 2 appliance
Technical data AC/DC adaptor:
Input: 100-240V 50/60Hz, 1.0A
Output: 12V 2.0A, 24W
Class 2 appliance
UK: INSTRUCTION MANUAL
5