CANGAROO HARMONY Gebrauchsanweisung Seite 13

Frequency
Communication range
Optimal room temperature where the units are used
Optimal room temperature where the baby monitor is stored
Permissible humidity in the room of use of the device
Two – way communication option
Voice Activation
Low battery indicator
Night lamp on the baby unit
See Figure BU: NL – night lights; PL – power indicating light; SL – signal indicating light; AL – audio indicating light; L ON –
turning on the night lamp; L – turning on the flashing lights; ON/ OFF – power on or off of the devise; C – charging jack.
See Figure MU: PL – power indicating light; SL – signal indicating light; „V+" – volume up; „V-" - volume down; ON/ OFF –
power on or off of the devise; C – charging jack.
ADAPTOR AND CHARGING THE BUILT-IN BATTERIES OF THE DEVICES
1.Before first use charge the batteries of the baby unit and mother unit completely.
2.The chargers are with the following specifications: Input: 100V – 240V- 50/60Hz; Output: 5V 1A 5.0W. The
AC chargers are with low voltage.
3.Charging:
-Connect the charger to the designated charging jack.
-Connect the charger's plug into electrical outlet of the mains supply of your home. The plug is used to connect the device
to the power supply, the device must be easily accessible.
-We recommend you to leave the devices to charge completely before next use to in order to prolong their battery life.
 WARNING: The provided chargers are with special design suitable for this product. They cannot be used for other
appliances. You should not use other types of chargers for this baby monitor, which are not provided by the
manufacturer/ importer.
4.Charge the appliances immediately after the light indicator starts flashing in red. After the batteries are completely
charged, the light indicator will blink in green.
5.If you will not use the product for a long time, charge the batteries of both of the units completely before storing them.
Then charge the batteries at least once a month to prolong its life.
6.The built-in batteries cannot be taken out of the product.
7.If the batteries are damaged or cannot be charged anymore, do not try to open the appliance. For consultation and
repair contact the shop from which you bought the product or the importer/ distributor.
8.The batteries are recyclable. If the product is damaged and cannot be used any longer, take it to an official collection
point for electronic products' waste, batteries, chargers. DO NOT throw the product away with the household waste.
Follow your country's rules for the separate collection of electrical and electronic products and rechargeable batteries.
Dispose of waste of this type only at the designated places. This will be important and significant contribution for the
environmental protection and the reduction of the harmful effects of the substances contained in batteries and electronic
components on the environment and human health.
 WARNING! CHARGE COMPLETELY BOTH OF THE DEVICES BEFORE FIRST TIME USE!
1.ON/ OFF button: Press and hold the button for a few seconds to turn on the sender and the receiver. The indicating
light will flash in green colour showing that the devices are turned on. They should be away from each other in order to
avoid interference in the signal.
2.Place the sender in the room of the baby. Point the microphone towards the child, e.g. to the baby bed or play area. It
should be at least 1 to 2 meters away from the child. If you have plugged the charger into the sender and mains outlet,
fully extend the cable to achieve the best possible transmission.
PARTS OF THE BABY UNIT (SENDER)
PARTS OF THE PARENT UNIT (RECEIVER)
USE OF THE PRODUCT
2.4GHz (2402 ~ 2480MHz)
≥300m (in open area)
0 ~ 45°C
25°C
20% - 80% RH
No
Yes
Yes
Yes
12