Installation - AutoAqua SMART ATO micro SATO-120P Bedienungsanleitung

All manuals and user guides at all-guides.com

Installation

1. Mount the optical level sensor on the tank/sump.
2. Plug the siphon breaker into the tubes, keep it higher than the water
level of the reservoir, and set up the water tube by the universal holder.
3. Connect both of the DC pump and power adapter with the controller
and then connect power.
Air In
Water Out
PUMP POWER
Power
LED Indicator
LED Color
Blue LED
*
Red LED
* Please check the tank/sump and then reset (unplug and replug power cable)
Siphon breaker must be higher than the
water level in the reservoir.
Air In :
break the siphon when the pump turns off.
Water Out :
Direction
are normal when the pump is on.
Optical Level Sensor
Tank/Sump
Status
Light on
Flashing
Flashing with audible alert
Siphon breaker allows air in to
Water drops out of the hole
Reservoir
Meaning
Power on
Refilling / Pumping
1.Water empty
2.Bubble noise
English
DC Refill Pump