INTERTECHNO ITD-250 Bedienungsanleitung Seite 21

GB
Operating instructions
ITD-250/251
Erasing individual codes:
Proceed as described in points 4.) and 5.), however, press the OFF button instead of
the ON button.
Erasing all codes
Press the learn button (L) for around 6 seconds until the LED begins to flash.
Briefly release the button and then press the learn button (L) again.
The LED will flash 3x as confirmation of the delete process.
No transmitters are required for this process.
Jog dial for setting the minimum brightness level (Fig. 4)
Switching on/off
For non-dimmable lamps the jog dial is set to the ON-OFF position.
DIMMER setting
This dimmer can be used for both dimming methods (lead and trailing edge), please
check the data sheet of the lamp or transformer.
Leading edge: Turn the setting wheel anticlockwise
Trailing edge: Turn the setting wheel clockwise
If the selected minimum brightness is too low, the lamp will go out (or flicker) at the
lowest dimming level. In this case the minimum brightness should be set slightly
higher.
Dimmer operation
When switched on, the dimmer run is started when another ON-signal comes from
the transmitter and is stopped at the desired brightness.
To dim with the button, keep the button pressed until the desired brightness is
reached. (ITD-251)
The light switch is used to start and stop the dimmer run by quickly switching it off
and on. (ITD-250)
If it is not stopped, the dimmer run remains at the end value (min. or max. bright-
ness).
To view the declaration of conformity, please visit www.intertechno.at/CE