EAS ELECTRIC EHF201 Bedienungsanleitung Seite 17

Always plug the heater directly into a wall

socket. Avoid using extension leads where
possible as they may overheat and cause a
risk of fire.
Do not use this appliance with an externa!

programmer, timer switch or any other
devise which would switch the device on
automatically unless this has already been
pre-built into the appliance by the manufac-
turer.
 Do not kink or wrap the power cord and plug
around the appliance, as this may cause the
insulation to weaken or split, particularly
where it enters the appliance.
Ensure the mains cable is fully extended

before use and arrange it so that it is not in
contact with any part of the appliance.
 Do not pull on the mains cable. Never move,
carry or hang the appliance by the mains
cable. The heater should not be used in a
room, of which the floor area is less than 5m2.
 Do not operate the appliance with any safety
guards removed.
Do not operate the appliance if there are

signs of damage to the appliance, power
cord, or any of the accessories.
lf the supply cord is damaged, it must be

replaced by the manufacturer, its service
agent or a similarly qualified person in order
to avoid a hazard.
5 V.1