glemgas GHW97BK Bedienungsanleitung Seite 5

the drill holes of the bracket Z previously
affixed to the wall (fig.9).
RECIRCULATING MODE INSTALLATION
In order to transform your cooker hood
from the exhaust version to the recirculating
version, put the active carbon filters on each
side of the motor, in the middle and turn
them till the stop (fig.4).
ELECTRICAL CONNECTION
Check that the mains voltage complies
with the one required by the hood. This is
indicated on the plate that is applied inside
the appliance.
OPERATING CHECKS
Check lights and motor start-up on all 3
speeds.
USE INSTRUCTIONS
Touch control on inox
Second suction speed
SAFETY INSTRUCTIONS
In certain circumstances electrical
appliances may be a danger hazard.
• The hood has been designed to remove
the kitchen smells; any other additional use
(Fig.1)
Fan-off
First suction speed
(minimum)
(medium)
Third suction speed
(maximum)
Light ON/OFF
shall be regarded as non-intended.
• Aerate the room if other appliances that
are not supplied by electrical power are
being used while the hood is on.
• Do not leave the cooker on if it is not being
used.
• Do not flambé food directly under the
cooker hood to prevent the grease filter
catching fire due to flames.
• Constantly check food frying to avoid
that the overheated oil may become a fire
hazard.
• Do not check the status of the filters while
the cooker hood is operating.
• Do not touch the light bulbs after or during
appliance use.
USE AND MAINTENANCE
It is recommended to switch on the
appliance before cooking. It is also
recommended to leave the appliance in
operation for 10 minutes after cooking is
terminated in order to completely eliminate
cooking vapours and odours. The proper
function of the cooker hood is conditioned
by the regularity of the maintenance
operations, in particular, the active carbon
filter and the grease filter.
Clean the fan and other surfaces of the
cooker hood regularly using a cloth
moistened with denatured alcohol or non
abrasive liquid detergent.
WARNING: unplug the appliance or switch
off the circuit breaker before carrying out
maintenance operations.
METAL ANTI-GREASE FILTERS (Fig.2M)
The metal anti-grease filters capture the
grease particles of the vapours that develop
during cooking, therefore they are subject
to clogging according to the frequency of
the use of the appliance.
In order to prevent fire hazard, it is
recommended to clean the filter every
2 months by carrying out the following
instructions:
• Remove the filters from the cooker hood
and wash them in a solution of water and
neutral liquid detergent, leaving to soak.
• Rinse thoroughly with warm water and
5